Outlaw Street Stock 4x4 Pickup Rules
1. Must be factory production vehicle. Truck, engine, and frame must be of the same manufacturer. Must be full bodied. DOT LEGAL. Vehicle must be licensed and insured and proof is required.
2. Fender cut outs allowed. Flatbeds allowed.
3. Multiple shocks allowed. No blocks or solid suspension allowed. No traction bars allowed. Frames can be boxed but must remain stock appearance. Bumpers must be stock and unaltered or you have the option of running without. Maximum wheel base 133”.
4. Must have all glass intact. Vehicle may not be stripped!! No body alterations period.
MAY HAVE TILT FRONT, ALL STEEL FRONTEND.
5. Must have brakes. Must be able to skid 2 tires.
6. Exhaust must exit under chassis. Headers allowed. Must have mufflers.
7. Engine must be in stock location, or no less than 14” from center of front axle to the front of the bell housing.
8. No aluminum blocks allowed. Engines (blocks & heads) must be cast iron per the make of the pickup chassis. No hemispherical heads. Engines must be stock appearing – Modifications to the carb, intake manifold, exhaust manifold (headers), and ignition system are allowed. Must use a single carburetor. No power adders such as nitrous, blowers, superchargers, etc. Any cast aluminum 4 barrel intake allowed.
9. Electric fuel pumps allowed. Engine must run on some sort of gasoline (race gas) or E85. No nitro methane or straight alcohol, etc.
10. All safety equipment Highly Recommended – loops, scatter shield (manual) / tranny blanket (automatic), and kill switch.
11. Weight added to front of vehicle may not exceed 185” from center of rear axle.
12. Adjustable hitch allowed. Height 26” maximum measured at point of hook. No chain hooks. Hitch height check with weights on.
13. Hitches must be rigid in all directions and not supported any further forward than 12 inches from the stock end of the frame rail.
14. Maximum tire size 35x12.50. Maximum 10 inch rim – inside bead to bead. No duals. Must be DOT approved tire. No alterations to tread allowed. No cyped tires. If wheel tread is offset, center line of front tire must run within tread of back tire.
15. No nitrous oxide.
16. All trucks must use stock appearing transmission and transfer case.
17. Drive trains of 1 ton or less.
PURE STREET STOCK 4X4 GAS PICKUPS RULES
FLOYD CO. PULLERS
2011
1. THIS IS A PURE STREET STOCK 4X4 GAS AND NATURALY ASSPIRATED DIESEL(non turbo) PICKUP CLASS FOR THE OWNERS OF TRUCKS THAT ARE LEGAL FOR HIGHWAY USE. IF YOUR TRUCK IS STREET LEGAL AND IS BUILT TO THE RULES SET FORTH HERE IN, YOU CAN ENTER THIS CLASS.YOU MUST HAVE CURRENT REGISTRATION, INSURANCE, LICENSE PLATE AND TRUCK MUST BE REGISTERED.
2. STUDDED TIRES, TIRE CHAINS, OR ANY
3. TRUCK CAN WEIGH UP TO BUT MUST NOT WEIGH ANYMORE THAN 6500 POUNDS. Weights and ballast must be securely fastened. No weights outside the body. TRUCKS WITH SNOW PLOW MOUNTS WILL BE ALLOWED TO PULL WITH UNWEIGHTED MOUNT ONLY. NO PLOWS. TRUCKS WITH FLATBEDS ARE ALLOWED BUT MUST NOT LOSE ANY DEBRIS OFF THE BED OR YOU WILL BE DISQUALLIFIED.
4. THE HITCH POINT WILL BE FROM A REAR BUMPR OR A "REESE" TYPE HITCH ONLY.(RECIEVERS) NO OTHER TYPES OF HITCHES ARE PERMITTED. NO "TRICK" HITCHES SUCH AS LEVER, PIVOT, AXIS OR ANGLED WILL BE PERMITTED. ALL HITCHES MUST BE STATIONARY IN ALL DIRECTIONS AND MUST BE NO MORE THAN 22 INCHES FROM THE GROUND. HOOK FROM A CLEVIS PREFERABLY BOLTED TO THE DRAWBAR/RECIEVER.
5. NO ALUMINUM ENGINE BLOCKS UNLESS OEM. NO OPEN HEADERS WILL BE PERMITTED. MOTOR MUST MATCH MAKE OF TRUCK (CHEVY IN CHEVY/FORD IN FORD ETC. ETC.). PUMP GAS AND A NATURALY ASSPIRATED DIESEL WILL BE THE ONLY FUEL PERMITTED. ABSOLUTELY NO ALCOHOL, NITROUS OXIDE, OR OTHER OXYGEN EXTENDERS. ALL EXHAUST MUST RUN THROUGH A MUFFLER SYSTEM, NO SUPERCHARGERS OR TURBOCHARGERS UNLESS OEM.
6. NO COMPUTER MODIFICATIONS ALLOWED SUCH AS PERFORMANCE CHIPS OR PROGRAMMERS. THIS WILL BE LEFT UP TO THE INSPECTORS/ OFFICALS AND THEIR DECISSION WILL BE FINAL
7. ABSOLUTELY NO BLOCKED SUSPENSION, PINION NUBBERS OR LADDER BARS! LEAF SPRING SUSPENSION ONLY. LIFT KITS WIIL BE ALLOWED AS LONG AS THE HITCH HEIGHT IS WITHIN 22 INCH LIMIT.
8. IF DRIVER OR ANY OTHER PERSON MAKES CHANGES TO TRUCK AFTER INSPECTION, BOTH TRUCK AND DRIVER WILL BE DISQUALIFIED.
9. ANY TRUCK WITH SIGNIFICANT POTENTIAL OF RISK TO IT'S DRIVER, TRACK OFFICIALS,SPECTATORS, AND/OR ANYONE ELSE WILL NOT BE ALLOWED TO PULL UNTIL SAFE CHANGES HAVE BEEN MADE. THIS IS UP TO OFFICALS’ DISCRETION!
10. ALL TRUCKS MUST HAVE WORKING LIGHTS.
11. TAILGATE MUST BE REMOVED OR IN CLOSED POSITION WHILE HOOKING, PULLING AND UNHOOKING.
12. ALL TRUCKS MUST HAVE A WORKING DRIVERS SIDE SEAT BELT AND DRIVERS MUST WEAR THEM WHILE PULLING.
13. ALL TRUCKS MUST BE IN NEUTRAL OR PARK WHILE BEING HOOKED AND UNHOOKED AND DRIVERS SHALL HAVE BOTH HANDS IN AIR DURING THIS TIME.
14. ALL MACHINE/ DRIVETRAIN EQUIPMENT SUCH AS SCATTERSHIELD, SCATTER BLANKET, DRIVESHAFT LOOPS, AND U-JOINT COVERS STRONGLY RECOMMENDED BUT NOT REQUIRED.
15. GAS TRUCKS ONLY. DIESELS WILL BE PREFERRED TO THE DIESEL CLASS OR DEPENDING UPON DIESEL PROFORMANCE MODIFICATIONS WILL BE UP TO THE OFFICIALS’ DISCRETION AT TIME OF THE PULL.
16. ALL TRUCKS WILL GO THROUGH AN INSPECTION AT THE SCALE BEFORE LINING UP TO PULL.
17. THIS CLASS IS A CAST IN HEADERS OUT, OR AN ALUMINUM IN, AND CAST OUT. MEANING- YOU CAN RUN AN ALUMINUM INTAKE HOWEVER YOU MUST HAVE CAST IRON EXHUATS MANIFOLDS. OR YOU CAN RUN A CAST IRON INTAKE WITH HEADER EXHUAST MANIFOLDS. NOT BOTH!!!!
18. VEHICLE MUST PULL 14LBS OF VACCUM AT A STEADY 1000 RPM.
19. VEHICLE MUST HAVE A STOCK IGNITION SYSETM ONLY. NO MSD OR ANY AFTERMARKET IGNITION SYSTEMS ALLOWED.
20. NATURALLY ASSPIRATED DIESEL PICKUPS WITHOUT TURBOS ARE ALLOWED. NO PERFORMANCE CHIPS/PROGRAMMERS ALLOWED.
$200.00 PROTEST RULE! IF YOU BELIEVE SOMEONE TO BE ILLEGAL YOU MUST HAVE $200 IN HAND TO TALK TO OFFICALS. IF FOUND ILLEGAL, MONEY IS RETURNED TO PROTESTOR AND OTHER DRIVER IS DISQUALIFIED. IF FOUND NOT ILLEGAL, $200 GOES TO FLOYD COUNTY PULLERS- PROTEST MUST BE BROUGHT UP TO OFFICALS IMMEDIATELY AFTER CLASS HAS FINISHED. PROTESTS CAN ONLY BE ON RULES LISTED ABOVE. (EX. BLOCKS, ENGINE, WEIGHTS, TIRES, EXHAUST, ETC.)
ANY QUESTIONS FEEL FREE TO CONTACT :
BRAD FARMER
1-641-330-1863